Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ1-(M3-M4)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
Datasheets(X)
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 20 x 5 mm |
Last viewed
Welding wire Steel SG 2
ASSY® 3.0 zinc-plated blue chipboard screw
3/8" socket wrench insert Inch, hexagon, short
Rechargeable LED Head lamp Ergopower Sensor
Soldering fluid brush For soldering fluid no. 41
Magnetic core drill MKB 35
3C cutter knife with slider
Pressure gauge bridge For R134a and R1234yf air-conditioning units
Base S2 FLEXITEC® safety boots
Hex head screw with shank ISO 4014, steel 8.8, zinc-plated, blue passivated (A2K)