Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ4-(M10-M11)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
Datasheets(X)
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 30 x 11 mm |
Last viewed
1/4 inch socket wrench insert, metric short
Speed cutting disc For steel
Two-ply lifting strap
Foam insert for empty compartment size 5
High-end power LED pocket torch Limited edition
Builder's bucket, zinc-plated
1'' torque wrench
Image S3 FLEXITEC® ESD safety boots
RW-edition blade scraper set 52 pieces
Tap wrench DIN 1814 Performance, adjustable