Die stocks DIN 225
Threading die holder DIN 225
HOLD-THRDIE-DIN225-SZ6B-(M16-M20)
Register now and access more than 125,000 products
Durable design and secure fastening
Housing made of die-cast zinc with knurled clamping screws and 90° tip for mounting die.
Datasheets(X)
The die is placed in the die holder at the height of the middle screw. The screws are tightened with a screwdriver. The die is placed vertically on the workpiece. Can be used on both sides. When cutting, sufficient cutting oil must be added. After two revolutions, the cut can be broken by briefly turning back.
Material | Malleable cast iron |
Internal diameter x height | 45 x 18 mm |
Last viewed
ORSY®clamping pins (sleeves), assortment of 100
Multi-Tester Pro II LED two-pin voltage tester
Elbow pipe wrench S-jaw, Swedish form
Hand-held rivet pliers With long nozzle
Pneumatic impact screwdriver DSS 1/2'' Standard
VDE screwdriver, flat slotted
Screws, cylinder head, assortment 960 pieces
Dynamometric screwdriver 1/4 inch
1/2-inch impact socket wrench insert hexagon, metric, long
1/2-inch impact socket wrench insert For hexagon socket screws, metric, long