EURASOL® nail sealing tape
EURASOL nail sealing tape
NLSEALTPE-3X60MM-10M
EURASOL
Register now and access more than 125,000 products
Satisfies the requirements of the ZVDH Directive
Nail seals are required for temporary covers and if the standard roof pitch is underrun. EURASOL nail sealing tape protects against water penetration, and therefore meets the requirements of the ZVDH.
Closed-cell soft foam offers maximum reliability
Soft, elastic foam moulds very closely around nails and staples to provide maximum protection against damage caused by water entry during the construction phase.
High adhesive power
Excellent adhesion on underlay membranes and wood simplifies installation.
Solvent-free for excellent material compatibility
High temperature resistance
Resistance to penetration of water
Tested by Fraunhofer Institute for Building Physics in Stuttgart in line with DIN EN 13111.
* Please observe our building-specific warranty conditions.
The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
Outdoors:
When fastening the securing battens on the rafters, nails or screws penetrate the underlay membrane or roof protective film. These points can lead to water entry with construction damage in case of rain. EURASOL nail sealing tape seals reliably here, thereby protecting against damage and meeting the requirements of the ZVDH guideline.
Indoors:
For sealing nailing and stapling areas on vapour barriers and vapour retarders.
Please note that the application surface must be dry and free of grease, dust and chips.
Outdoors:
Apply EURASOL nail sealing tape either on the underside of the securing battens or on the outside of the underlay membrane parallel to the rafter. Then the counter batten is fastened on the rafter, compressing the nail sealing tape in the process.
Indoors:
Apply EURASOL nail sealing tape to the rafters or the vapour retarder/vapour barrier.
Material | PE - Polyethylene |
Adhesive base | Acrylate dispersion |
Colour | Anthracite |
Overall thickness | 3 mm |
Length | 10 m |
Width | 60 mm |
Ultraviolet resistance | 2 years, outdoor weathering |
Min. processing temperature | 0 °C |
Max. processing temperature | 40 °C |
Min. temperature resistance | -40 °C |
Max. temperature resistance | 90 °C |
Shelf life from production | 24 Month |
Solvent-free | Yes |
Conditions to maintain shelf life from production | at 20°C |
