Hammer drill bit Plus Quadro-S
Hammer drill bit Plus Quadro-S
DRL-MN-PLUS-QUADRO-S-4SPRL-22/250/200
Register now and access more than 125,000 products
No hooking in
The drill bit tends to hook into reinforcements to a far lesser extent thanks to the geometry with four cutting edges.
Precise spot drilling
The special self-centring point enables precise spot drilling.
Greater precision
This is the result of the four cutting edges of the drill bit head being better positioned in the drill hole, as well as the four-spiral drill bit helix and the smaller friction surface. The four large-volume feed helixes ensure fast transport of drilling dust.
Please note: With long drill bit lengths, pre-drill with a short drill bit of the same diameter!
Iron reinforcements may only be drilled through with permission from a structural engineer.
Datasheets(X)
Drilling speed (point system) | 3 of 4 points |
Smoothness of running (points system) | 3 of 4 points |
Accuracy (point system) | 2 of 4 points |
Reinforcement strength (points system) | 2 of 4 points |
Service life (points system) | 2 of 4 points |
Diameter (Ø) | 22 mm |
Length | 250 mm |
Working length | 200 mm |
Number of cutting edges | 4 PCS |
Number of spirals | 4 PCS |
Tool holding device | Suitable for SDS-plus |
Last viewed
Folding rule fibreglass-reinforced
ORSY®circlips, assortment of 100
1/4" socket wrench insert metric, long
1/2-inch socket wrench insert, TX head For external TX screws, short
Hexagon socket bit
O-ring, metric
1-inch impact socket wrench insert hexagon, metric, short
Flat washer without chamfer DIN EN ISO 7089, steel, hot-dip galvanised (hdg)
Cetus fleece jacket
Hand tap, taper tap HSS DIN 352