Nail HN 101 For use in steel and concrete substrates
Nail HN 101
NL-HN101-52MM
Register now and access more than 125,000 products
Nails with shaft lengths of 72, 90 and 100 mm must be pre-tapped into place with a hammer. Please observe the corresponding device category when selecting your fasteners
Length calculation for nails used on concrete surfaces:
Penetration depth (min. 25 mm/max. 40 mm) + thickness of component to be fastened = nail or shaft length
Length calculation for nails used on steel surfaces (min. 5 mm thick):
Penetration depth (min. 8 mm/max. 12 mm) + thickness of component to be fastened = nail or shaft length
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
High-quality nail for steel substructures and concrete substrates (normal weight concrete ≥ C 12/15 ≤ C 50/60) in accordance with DIN EN 206
 | |
Material | Steel |
Surface | Zinc plated |
Design | Smooth |
Head type | Step head |
Shaft length (SL) | 52 mm |
Length (L) | 52 mm |
Shank diameter (Øds) | 3.7 mm |
Head diameter (Ø dk) | 8 mm |
Suitable for device type | Würth BST 350, Hilti DX 2, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Crimping tool with parallel loading
ASSY® 3.0 zinc-plated blue chipboard screw
High-pressure hose HDR 160 C/185 PP
Tension springs with double eyelets assortment 368 pieces in system case 4.4.1. DIN 2097
Tile drill NDS 68
Core drill DS130-T
1/2 inch socket wrench insert metric, hexagon, long
Car Windscreen Wiper Conventional Standard
O-ring, imperial NBR 70
3-component safety knife With fully automatic blade retraction after cutting