Nail HN 101 For use in steel and concrete substrates
Nail HN 101
NL-HN101-62MM
Register now and access more than 125,000 products
Nails with shaft lengths of 72, 90 and 100 mm must be pre-tapped into place with a hammer. Please observe the corresponding device category when selecting your fasteners
Length calculation for nails used on concrete surfaces:
Penetration depth (min. 25 mm/max. 40 mm) + thickness of component to be fastened = nail or shaft length
Length calculation for nails used on steel surfaces (min. 5 mm thick):
Penetration depth (min. 8 mm/max. 12 mm) + thickness of component to be fastened = nail or shaft length
All nails are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
High-quality nail for steel substructures and concrete substrates (normal weight concrete ≥ C 12/15 ≤ C 50/60) in accordance with DIN EN 206
 | |
Material | Steel |
Surface | Zinc plated |
Design | Smooth |
Head type | Step head |
Shaft length (SL) | 62 mm |
Length (L) | 62 mm |
Shank diameter (Øds) | 3.7 mm |
Head diameter (Ø dk) | 8 mm |
Suitable for device type | Würth BST 350, Hilti DX 2, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Multi-standard trousers
Polishing pad, blue
EPS profile thumbturn cylinder
Washer DIN 9021 (with large outer diameter), steel, hot-dip galvanised
ORSY®split pins, assortment of 100
Welding glove Lefty
Turned flat washer DIN 7989-2, zinc-plated steel, blue passivated (A2K), for steel construction
3/4 inch connector with 1 inch square drive and ball locking mechanism
3/8" socket wrench insert Inch, hexagon, short
Stretch Evolution softshell jacket